POOL CARE GUIDE · NORTH TEXAS

How to do a pool bucket test

Is your pool leaking or just losing water to evaporation? This simple test helps you check.

Pump off24 hoursTwo measurements
Bucket test setup on a submerged pool stepA stable bucket sits partly underwater with its rim above the pool. One arrow tip touches the bucket waterline inside; another touches the pool waterline outside. Measure the drop from each arrow tip after 24 hours.INSIDE MARKBucket waterOUTSIDE MARKPool waterStable pool step5-GALLONBUCKET
Draw one arrow inside and one outside the bucket.
Setup illustration, not to scale.
THE SHORT ANSWER

Start with the pump off for 24 hours.

Water evaporates from both the bucket and the pool. If the pool’s water level drops farther than the bucket’s, your pool may have a leak.

Have a connected spa? Call us before starting. Water moving between the spa and pool can affect the result. We’ll help you choose the right setup.

THE METHOD

Follow these six steps.

  1. Turn off the pump and automatic water fill

    Leave both off for the entire 24-hour test. Turn off the heater, pool cleaner, and water features too. Make sure scheduled settings will not turn them back on during the test.

  2. Fill a bucket with pool water

    Use a clean 5-gallon bucket that does not leak. Fill it to about 1 inch below the rim.

  3. Set the bucket on a pool step

    Choose a step or bench where about two-thirds of the bucket sits underwater. Keep the rim above the pool water. The bucket must stay upright without floating.

  4. Draw an arrow at each waterline

    Inside the bucket, draw an arrow with its tip touching the bucket’s waterline. Outside the bucket, draw another arrow with its tip touching the pool’s waterline. Use a waterproof marker, as shown above.

  5. Wait 24 hours

    Take a starting photo and note the time. Keep the pump and automatic fill off. Do not swim, add or drain water, or move the bucket. If it rains, restart on a dry day.

  6. Measure below each arrow

    Measure from the inside arrow tip down to the bucket’s new waterline. Then measure from the outside arrow tip down to the pool’s new waterline. Write down both measurements and compare them below.

AFTER 24 HOURS

Did the pool drop more than the bucket?

Compare the two distances you measured below the arrows.

ABOUT THE SAME DROPBUCKETPOOLArrow tips = each starting mark

Similar drops suggest evaporation.

The pool and bucket lost about the same depth of water during this test. If your pool keeps losing water, contact us.

POOL DROPS MOREBUCKETPOOLArrow tips = each starting mark

A larger pool drop suggests a possible leak.

Save both measurements and a photo. We can help you decide what to check next.

For example

Bucket drop: ¼ inch. Pool drop: ¾ inch. The pool dropped more, which suggests a possible leak.

Hard to tell the difference? Repeat the test or send us your photos for help.

COMMON QUESTIONS

Questions about your test

What do I do when the test is finished?

Photograph your measurements, then remove and empty the bucket. Make sure the pool water is at a safe operating level before restoring your normal equipment settings. Keep children and pets away from the bucket throughout the test.

What if it rains or the bucket moves?

Start again during a dry 24-hour period. Rain, added water, swimming, or a moved bucket can make the result unreliable.

What if the drops match, but my pool keeps losing water?

Contact us with your measurements. This test checks water loss with the pump off. Some leaks show up when the pump is running, so we may recommend a follow-up test.

Will this test show where a leak is?

No. It helps you check whether your pool is losing more water than evaporation would explain. Finding the source requires further investigation.

PRIMAL POOL CARE

Not sure what your results mean?

Send us the bucket drop, the pool drop, and your photos. We’ll help you understand the results and discuss the next step.

Learn about our pool diagnostic service
CallRequest Service